Doug Fleenor Design Edison Arrayable 25 Lamp Panel Lighting Fixture
Edison is a 25 lamp fixture with 25 built-in dimmers. Lampsare spaced on six inch centers, three inches in from each edge. The 30 inch squarefixture is 1 3/4 inches deep and weighs 24 pounds (without lamps). Edison isarrayable to form large, low-resolution video walls. Steel straps running downthe back sides support fixtures hanging below. The front panel is solid1/10″ aluminum, free of visible hardware, and can be powder coated in avariety of colors (stock is silver).
Technical Specifications
DMX input circuit
Protected EIA-485 receiver (LT1785).
Input protection
Undamaged by up to 60 Volts continuous, 15KV transients.
Input signal
0.2 volts minimum, 12 volts maximum, DMX512, DMX512/1990, orDMX512-A.
DMX input connector
Gold plated 5 pin male XLR (Neutrik D-1 series) 3 pin XLRoptional.
Input pass through
Gold plated 5 pin female XLR (Neutrik D-1 series). All 5pins are fed through.
Termination
None. Unused pass through connectors must be externallyterminated.
Power input
120 VAC 60 Hz 20 Amps at full load. Actual current draw is0.05A plus lamp load.
Power input connector
Neutrik 20 Amp PowerCON chassis connector: NAC3MPA.
Mating cableconnector
NAC3FCA
Power pass through
Neutrik 20 Amp PowerCON chassis connector: NAC3MPB,
Mating cableconnector
NAC3FCB
Idle power
Less than 1 W att.
Power output
120 VAC 60 Hz 0.8 Amps (96W ) maximum per output.
Output protection
Outputs are designed to handle up to 600W overload withoutdamage.
Size and weight
30″ square x 1.75″ deep, 24 pounds (withoutlamps).
